Apple Xserve RAID - Manual (Page 26)

Mounting Xserve RAID in a Rack 27
Assemble the Brackets and Extenders
Follow these steps to assemble the brackets and extenders for the depth of your rack.
For a Rack 24 to 29 Inches Deep
1 Gather the two large brackets (items A1 and A2) and the two longer extenders (item B in the
illustration below), along with the necessary screws:
m six short screws for assembling two brackets and extenders
m four long screws for securing the brackets to the rack
m two mounting screws for attaching the system to the rack
2 Place the cut-out area of the extender (B) over the three posts that extend from the wider
side of the bracket A.
3 Fasten the bracket and extender together using three short screws and tighten the screws.
Note that you can still slide the extender backward and forward.
B
A1 and A2 Short screws
Mounting template
Pass three of the short
screws through the slot in part B and
attach them to part A1 or A2. Tighten them securely.
Make sure part B fits under the tabs on part A1 or A2.
B
A1 or A2