Apple Qmaster 2 and Compressor 2 (Distributed Processing Setup) User Manual
Page 17
Advertising
Chapter 1
Getting Started Quickly
17
Step 2:
Configure a QuickCluster
Use the Apple Qmaster pane in System Preferences to configure the cluster controller
and service node computers.
1
Open System Preferences.
2
Click the Apple Qmaster button, located in the Other section.
The Apple Qmaster pane appears.
3
If the pane is locked, unlock it by clicking the padlock in the lower-left corner to enter
the administrator name and password.
4
Click Start Sharing.
This creates a QuickCluster with this computer as its controller, and an instance of
processing services for each processor on the computer.
UP01082.Book Page 17 Wednesday, March 16, 2005 5:12 PM
Advertising