Apple Logic Pro 8 Getting Started - Manual (Page 66)

66 Chapter 7 Mixing and Exporting Your Project
To send a channel to a bus:
m Click the top, unused Send slot of any channel, and choose Bus 1 from the menu.
The following happens:
 A new auxiliary channel strip (Aux 1) is created in the Mixer—with Bus 1 shown in
the Input slot (I/O section).
 A blue Bus 1 label appears on the Send slot of the channel, along with a small Send
Amount knob to the right of the slot.
To adjust the amount of the channel signal sent to the bus (aux channel):
m Vertically drag the Send Amount knob.
The use of EQ, instrument and effect plug-in slots—on all types of channel strips—is
discussed in Chapter 5, “
Using Instruments and Effects .”