Apple Xserve Intel (Late 2006) DIY Procedure for Rear ID Tab - Manual

 Xserve (Late 2006)
073-1112 Rev. A
Rear ID Tab
Replacement Instructions
Follow the instructions in this document carefully. Failure to follow these instructions could
damage your equipment and void its warranty.
Online instructions are available at http://www.apple.com/support/diy/.
Working Safely Inside the Xserve
Always touch the Xserve enclosure to discharge static electricity before you touch any
components inside the Xserve. To avoid generating static electricity, do not walk around the
room until you have finished working inside the server and have replaced the cover. To minimize
the possibility of damage due to static discharge, wear an antistatic wrist strap while you work
inside the Xserve.
Warning: Always shut down the Xserve and disconnect the power cords before opening
it to avoid damaging its internal components or the components you are installing. Don’t
open the server while it is turned on. Even after you shut down the Xserve, its internal
components can be very hot. Let it cool before you open it.
Tools Required
The following tools are required for this procedure:
Phillips #1 screwdriver
Antistatic wrist strap (if available)
2 thermal grease syringes for replacing processor heat sinks (supplied with the replacement
part)
2 alcohol wipes for cleaning processors and heat sinks (supplied with the replacement part) •
•
•
•