Apple Remote Access MultiPort Server - Manual (Page 22)

7 Click OK when you have finished entering information and selecting security options.
If you do not enter an Administrative Password, the following warning appears:
8 Click OK to confirm that you do not want to enter an Administrative Password, or click
Cancel to enter an Administrative Password.
Note: To change the Server Preferences at any time, choose Set Server
Preferences from the Server menu.
Configuring the modem ports
IMPORTANT You cannot use the built-in serial ports on the computer for
Apple Remote Access. Use only the ports provided on the installed serial
card or cards.
This section describes how to configure the modem ports for dial-in and callback
access. Before continuing, make sure that you’ve installed all expansion cards
and attached all serial communications devices correctly.
There are three basic ways to configure the modem ports: Dial-in Access, Dial-in
and Transfer, and Callback Only.
Note: Users cannot access a configured port until it has been turned on in the
Port Configuration window, as described later in this chapter.
22 Chapter 3 / Setting Up the Server