Apple Xserve User Manual
Page 36
36
Chapter 2
Installing or Replacing Components
To install memory:
1
Review the memory installation rules and make sure you have the right type of DIMMs.
2
Shut down the Xserve and unplug all cables.
Important:
Be sure the Xserve is turned off and the power cords are unplugged before
you install or remove memory.
3
Remove the Xserve from the rack and open it. For instructions, see “Opening and
Closing the Xserve” on page 30.
4
Open the ejectors on a slot by pushing them outward.
Important:
Don’t touch the gold connectors on the DIMMs.
5
Without touching its gold connectors, align a DIMM in the slot and push straight down
on both ends until the DIMM is seated and the ejectors snap upright.
6
Repeat for the second DIMM of the pair and for additional pairs.
Important:
Be sure to add DIMMs in the order shown in the illustration.
WARNING:
Always wait 5 to 10 minutes for the Xserve to cool down before you try to
install memory. DIMMs that are already installed and other components near the
DIMM slots may be very hot.