BeefEater Discovery Series - Manual (Page 4)

4
Assembly Instructions
Before You Start
Note the tools you will need before you begin.
Remove any packaging material or protective plastic from
components.
Check for damaged or missing parts, and consult your retailer if
necessary.
Mobile trolleys are optional. You should follow the separate instructions that came with the trolley
before assembling and installing your barbecue.
Check The Cross Lighting Channels
The cross lighting channels should already be in place. If they are not, or if they moved
during shipping, they need to be replaced as follows: place each cross-lighting channel
onto the back support panel. The keyed tabs on the bottom of each cross-light channel
fits into the slots on the burner support rail. The cross lighting channels are required for
all models.
Check The Burners
The burners should already be fitted to the
barbecue. If they are not, or if they moved
during shipping, they need to be replaced as
follows:
Remove the retaining clip from the burners.
Fit the burners, open end first, over the stem of the control
valves at the front of the barbecue. Lower the other end of
the burner so the lug locates into the corresponding hole at
the rear of the barbecue.
Replace the retaining clips into the burner lugs so the
burners stay in position. You need to do this from behind the
barbecue, underneath the back panel.
Check Gas Type
Check that the gas type is correct for your type of gas. You will find the gas type label
on the side of your barbecue. If your barbecue is of the incorrect gas type, or if you
are unsure, consult your dealer before going any further.
NATURAL
GAS
RE
F E R
T O
L O
C A L
GAS AUTHORITY FOR CONFIRMATION OF GAS T Y P E
IF
IN
DO
UB
T
LPG
PROPANE
GAS
RE
F E R
T O
L O C
A L
GAS AUTHORITY FOR CONFIRMATION OF GAS T Y P E
IF
IN
DO
UB
T
Phillips Head
Screwdriver
adjustable spanner/
wrench