Apple Xserve Intel (Late 2006) DIY Procedure for Power Distribution Board - Manual (Page 13)

Xserve (Late 2006) Power Distribution Board Replacement Instructions 1
Tighten the five Phillips screws that fasten the airflow duct to the fan array, in the order
shown, to prevent the duct from warping. Do not overtighten the screws.
Replacing the Power Distribution Board Cable
Connect the power distribution board cable to its connectors on the drive interconnect
backplane and the power distribution board.
Replacing the Power Supplies
Slide the first power supply all the way into the bay, and then press the handle to seat it and
lock it in place.
Repeat for the second power supply, if installed.
Slide the power supply in and
press the handle to seat it.
Replacing the Apple Drive Modules
Slide the first Apple drive module into its bay until it is firmly seated. Then press the handle
in flush with the front panel.
Repeat for all other installed drive modules.
3.
1.
2.
1.
2.