Apple Motion 1.0.1: Late-Breaking News - Manual

1
1
Late-Breaking News
About Motion 1.0.1
Fixed Known Issues in Motion 1.0.1
The following Motion 1.0 known issues have been fixed in Motion 1.0.1.
Drop Shadow
On computers with ATI Radeon graphics cards, turning on the Drop Shadow checkbox
for a layer in the Layer Dashboard after changing the Blend Mode to something other
than Normal causes Motion to quit unexpectedly.
Keyframe Editor
When an object is animated (using keyframes) and Show is set to Active in the
Keyframe Editor, and you select then deselect the animated object in the Canvas, then
click in the Keyframe Editor, Motion may quit unexpectedly.
Monitors
If using a dual-monitor setup, the View pop-up menu may appear on your second
monitor when using the default Standard layout (View > Layouts > Standard).
PDF files
In the Media tab of the Inspector, the Fixed Width and Fixed Height parameters do not
function for imported PDF files when Fixed Resolution is turned on.
Hardware
CinéWave hardware installed on a computer is not recognized by Motion and does not
appear in the Output Preferences.
Masks
If a mask object is selected in the Canvas, and the mask is the bottom-most object in
the Layers tab or Timeline, pressing the
Up Arrow key and then the Down Arrow key
causes Motion to quit unexpectedly. This does not occur if there are non-mask objects
below the mask in the project.
Motion Blur
When a project with Motion Blur enabled (in the View menu of the Canvas) is exported
with the “Use current project settings” checkbox turned on (the default), motion blur is
not rendered.