Belkin F5D7630-4A - Manual (Page 57)

55
GLOSSARY
IP address
The “IP address” is the Internal IP address of the Router. To access the advanced
setup interface, type this IP address into the address bar of your browser. This
address can be changed if needed. To change the IP address, type in the new IP
address and click “Apply Changes”. The IP address you choose should be a
non-routable IP. Examples of a non-routable IP are:
192.168.x.x (where x is anything between 0 and 255.)
10.x.x.x (where x is anything between 0 and 255.)
Subnet Mask
Some networks are far too large to allow all traffic to flood all its parts. These
networks must be broken down into smaller, more manageable sections, called
subnets. The subnet mask is the network address plus the information reserved
for identifying the “subnetwork”.
DNS
DNS is an acronym for Domain Name Server. A Domain Name Server is a server
located on the Internet that translates URLs (Universal Resource Links) like
www.belkin.com to IP addresses. Many ISPs do not require you to enter this
information into the Router. If you are using a static IP connection type, then
you may need to enter a specific DNS address and secondary DNS address for your
connection to work properly. If your connection type is Dynamic or PPPoE, it is
likely that you do not have to enter a DNS address.
PPPoE (Routing Mode, for multiple PCs)
Most ADSL providers use PPPoE as the connection type. If you use an ADSL
modem to connect to the Internet, your ISP may use PPPoE to log you into the
service.
Your connection type is PPPoE if:
1. Your ISP gave you a user name and password which is required to connect to
the Internet
2. Your ISP gave you software such as WinPoET, Enternet300 that you use to
connect to the Internet