MBW MK8 121 - Manual (Page 8)

- 5 -
subsequent smoothing operations continue increasing the
blade inclination until obtaining the desired finish.
The time between one pass and the next is determined by
the temperature and by the amount of water in the concrete.
If the concrete has hardened too quickly in some areas, it
can be moistened by spraying a small amount of water
using the button located on the left control bar in order to
obtain the degree of finish desired.
Stopping Engine
1. Release the accelerator pedal to idle and turn off the
key.
2. Close the fuel valve and remove the start key from
the engine.
Hydraulic pressure regulation
The hydraulic operating pressure of the MK8-121 controls
the sensitivity of the controls and may vary between 10 and
20 bar (145 - 290 PSI). The regulator and gauge is located
behind the seat.
WARNING
Always stop the engine before:
Adding fuel.
Leaving the equipment unattended for any
amount of time.
Before making any repairs or adjustments to the
machine.
Fig. 1, Control
Moving Forward
Push both control levers forward.
Moving Backwards
Pull both control levers back.
Moving to the Right
Push control lever right.
Moving to the Left
Push control lever left.
Right turn
Push the left control lever forward
and pull the right control lever back.
Left turn
Push the right control lever forward
and pull the left control lever back.