MBW VS77M - Manual (Page 7)

- 4 -
• Make sure hands, feet, and clothing are at a safe
distance from any moving parts.
• The MBW Vibration Suppressor should only be run with
clean and dry compressed air. The use of an oil mist
lubrication system will improve the life of both the
Vibration Suppressor and the pole tamper
• Verify that all joints are tight
Operating Ergo and Pole tamps
WARNING
Follow all recommended operating procedures of
pole tamper manufacturer. Failure to do so could
result in serious bodily injury or death.
1. Connect air supply hose to trigger assembly
2. Grasp pole tamper assembly on the main body of the
Vibration Suppressor or anywhere above
WARNING
Do not place any part of body above pole tamper
assembly. Device will “Jump” when air is
activated.
3. Depress trigger to begin tamping.
4. Release trigger to stop device.
CAUTION
PINCH HAZARD: Avoid placing hands below main
body of the MBW Vibration Suppressor
• The MBW Vibration Suppressor is a spring loaded
device. Efficiency of isolation will depend on many
factors including air pressure, pole tamper type and
operator input. When operating, try to find the correct
down pressure that results in the least amount of
transmitted vibration.
Storage
• The MBW Vibration Suppressor is made of high quality
corrosive resistant components. To lengthen the life of
the entire tamper assembly, drop a small amount of light
oil into trigger assembly and run device for a minute
before long term storage.