Lull 944E-42 Operation Manual - Manual (Page 35)

Section 2 - Pre-Operation and Inspection
2-11 31200354
5. Cab and Electrical -
• General appearance; no visible damage.
• Frame level indicator and window glass undamaged and clean.
• Gauges, switches, joysticks, foot controls and horn operational.
• Check seat belt for damage, replace belt if frayed or cut webbing, damaged
buckles or loose mounting hardware.
6. Main Control Valve (under cab floor) - See Inspection Note.
7. Wheel/Tire Assembly - Properly inflated and secured; no loose or missing lug
nuts. Inspect for worn tread, cuts, tears or other discrepancies.
8. Stabil-Trak Cylinder - Pins secure; hydraulic hoses undamaged, not leaking.
9. Rear Axle - Steer cylinders undamaged, not leaking; pivot pins secure;
hydraulic hoses undamaged, not leaking.
10. Wheel/Tire Assembly - Properly inflated and secured; no loose or missing lug
nuts. Inspect for worn tread, cuts, tears or other discrepancies.
11. Transfer Carriage - See inspection note. Transfer carriage cylinder pins secure;
hydraulic hoses undamaged, not leaking.
12. Engine Compartment -
• Drive belts, check condition and replace as required.
• Engine mounts - See inspection note.
• (Before S/N 0160041827 including 0160041630) Battery cables tight, no
visible damage or corrosion.
• Engine cover closed and properly secured.
13. Wheel/Tire Assembly - Properly inflated and secured; no loose or missing lug
nuts. Inspect for worn tread, cuts, tears or other discrepancies.
14. Frame Level Cylinder - Pins secure; hydraulic hoses undamaged, not leaking.
15. Attachment - Properly installed, see “Attachment Installation” on page 5-10.