CompuSTAR RF-P2W901-SS (Remote 2W901R-SS) - Manual (Page 20)

Remote Start Error Diagnostic
If the remote start fails to start the vehicle, the parking lights will flash three times immediately. Following those three flashes the parking lights will
flash again corresponding to the error table.
We recommend that you do not attempt any repairs on your remote starter. Contact your dealer or call us directly.
Number of Parking Light Flashes Remote Start Error
1 Motor running
2 Key in ignition on position
3 Door open (manual transmission only)
4 Trunk open
5 Foot brake on
6 Hood open
7 Reservation off (manual transmission only)
8 Tach or voltage sensing failure
Remote Coding / Programming Routine
Dfc[fUaa]b[&KUm)6ihhcbFYachYg.
STEP 1: Activate Valet/Programming mode by manually turning the ignition key on and off (between the Acc & On positions) five times within 7
seconds. The vehicle’s parking lights will flash once with the successful completion of this step
STEP 2: Within 2 seconds after cycling the ignition for the 5th time, tap the Lock button on 2 way remotes or the (lock) button on 1 way
remotes for 0.5 seconds. The parking lights will flash once to confirm the transmitter has been coded.
Exiting Programming: Programming is a timed sequence. The parking lights will flash twice signaling the end
of programming mode.
Programming Multiple Remotes: After the confirmation flash given in step 2, code additional remotes by
pressing button (I) on 2 way remotes or the (lock) button on 1 way remotes. The parking lights will flash
once confirming each additional remote. All systems (except the P2WSSR), can recognize up to three remotes.
!
IMPORTANT: Every Firstech remote must be coded to the system prior to performing any operations. All remotes must be coded at the same time.
By Firstech, LLC 38 39 By Firstech, LLC
2W901R-SS_ES USER GUIDE.indd 39-40 2011-3-26 14:34:24