Bench Dog Tools RT400 - Manual (Page 4)

4. Mount routertop to your custom base.
When mounting the routertop to your own base or leg set, use
the routertop's predrilled mounting holes with the bolts and
cross dowels provided. Use of any other hardware or mounting
method will void the warranty. You must locate and drill (8)
mounting holes according to the drawing below. Furthermore,
you must drill (8) cross dowel holes to intersect the mounting
holes, as shown to the right.
All distances are from center of hole to center of hole.
123.8
4.875"
16.378"
7.374"
11.5"
123.8 416
75.8
2.984" 7.559" 5.039"
75.8 192
Miter Track
Router Insert Plate
Miter Track
192 128
187.3
292.1
Top View
Dimensions in mm/inches.
Page 4
Skip step 4 if you
purchased a Bench Dog
ProTop Cabinet!
5
1/4-20 x 2"
phil. flat head
machine screw
Routertop
The cross dowel hole
is 7/16" in diameter,
9/16" deep!
Cross Dowel
Cabinet Panel
1-5/8"
Bolt
3/4"
Locate the center
of cross dowel
hole 3/4" from top of
panel, as shown.
Drill the
5/16" diameter
routertop mounting
holes 1-5/8" deep,
as shown.
The above drawing is provided to assist
you in locating the mounting holes for the
base you build. It is your responsibility to design an
adequately strong base to support the routertop, a
router, and your work.
5. Attach the miter track to the routertop.
First install (4) 1/4" cross dowels in the cabinet's front
stretcher. Use the (4) 1/4-20 x 2" phil. flat head machine
screws in track holes.