Lukas HTS 90 - Manual (Page 6)

10.4.2 Cutter set LSH - 3
Attention! Do not reach in between the cutter arms!
Live cables must not be cut apart.
Cutting objects under tension (shock absorbers, springs, track rods) is prohibited since cut-off
parts of these objects might jerk away unpredictably which exposes the operator and other
persons to a high risk of injury.
Hardened objects such as spring steel and steering pillars must not be cut.
The cutting equipment may only be operated in conjunction with a hand pump, and under no
circumstances is it to be driven by a motor pump. The operating pressure must not exceed
700 bar max.
11 Servicing and Maintenance
Oil should be changed once a year. In case of frequent use or operation in particularly dusty
environment, oil should be changed every six months.
11.1 Adding Oil to the Pump
Attention!
Always add oil with cylinders fully retracted (extended if pull cylinders) or the system will
contain more oil than the reservoir can hold.
- Remove vent/fill cap from reservoir.
- Fill reservoir only to level mark shown on pump.
- Remove air from system if necessary. See 9.1. Recheck oil level after removing air.
- Return vent/fill cap to proper position.
- Make sure no dirt gets into the oil reservoir or into the pump,
as this will cause malfunction.
- To extend pump life and improve performance, lubricate the
beam pin A, cross pin B and piston head C regulary, using
roller bearing grease. See cover page
12 Replacement of Cutting Blades on Cutter LSH-3
Ref. No. of cutting blades: 84150/6400-02.
Close drain valve on the hand pump (tighten hand wheel
smoothly clockwise)
Operate the pump lever until the two cutting
blades 1 nearly touch; the fastening bolt 2 of the movable
cutting blade is now accessible.
Carefully remove the fastening bolt 2 using a hammer and punch.
Remove the defective cutting blades 1 and replace with new ones.
Hammer the fastening bolt back. Replace defective bolts.
Open drain valve again.
Note:
Deformed or or broken cutting blades must not be resharpened.