Synergy 5203 - Jeep TJ/LJ Front Cage Kit User Manual
Page 8
Advertising
13. Make sure all the tubes are aligned and square or level. Tack weld all of the joints in
this order:
1. Lower A-pillar to floor plate
2. A-pillar splice over dash
3. Windshield cross tube to A-pillar
4. Spreader tubes to windshield and B-pillar tubes
5. Windshield brackets to A-pillar
6. DO NOT tack weld the dash bar until you completely weld the A-
pillar splice
14. Weld the A-pillar splice completely, then tack weld the dash bar into place, make sure
the tube is level
15. Weld the rest of the joints of the cage and weld the windshield bracket to the A-pillar.
16. Position the grab handles as shown below and weld into place
Advertising