Synergy 5204 - Jeep TJ Rear Cage Kit User Manual
Page 6
Advertising
9. Double check all measurements before tacking. Fit hard or soft top to ensure proper
clearance. Once satisfied, securely tack all tubes into position. Tack each tube in at
least 3 spots to help prevent distortion during final welding.
10. You can finish weld all of the tubes now. Remember, if you want to retain the
factory roll bar padding you will have to cut holes where the tubes attach, position the
tubes through the padding, slide the padding over the tubes and then weld for the
cleanest installation possible.
11. Clean the welds and paint the new tubes.
12. Installation is complete.
Advertising