Synergy 5502/4 - Jeep JK 2/4 Dr Rocker Guard Set User Manual
Page 3
mount bolts on rear, (middle 4-door) body mounts. Use the longer supplied bolt
for the front body mount. ***
Rocker Test Fitting
9. With all body mount hardware installed; tighten the body mount bolts and check
rocker guard position. This is easily done by comparing the horizontal door body
line with the top of the rocker. Also position rocker guards flush with the JK
rocker panel. The height of the rocker guard can be adjusted by loosening the
body mount bolts and moving the slotted mounts into the desired position.
10. If the rocker guard needs adjustment use the supplied washers to shim the front
body mount spacer assembly to get the desired level look.
11. Fully tighten the body mount bolts and do a final position check. If rocker guard
is level and flush with the JK rocker panel proceed to the next step. If not, make
the necessary adjustments.
12. With the body mount bolts tight and the rocker in the correct position, the rocker
panel holes can be marked for drilling. Insert a 25/64 drill bit through the holes in
the rocker to do this. The drill bit will center the hole. Drill all twenty holes
through JK rocker panel sheet metal.