Synergy 5501-02/04 - Jeep JK Rubicon Rock Rail Kit User Manual
Page 6
Advertising
Front footplate fitment
7) As for the rear plates, push them as far back as they will go. The rear notch in the
plate should line up with the curve in the new rocker tube.
Rear foot plate fitment
8) Once satisfied with fitment and location. Take note and mark the areas which
need to be cleaned up for welding.
a. Remove paint as needed. Be sure to clean up all areas near the edges of
the plates as this is where the small rocker tie in tubes will be installed.
Advertising