Synergy 5716-01 - JK Diesel HD Transmission Cross Member 07+ - Manual (Page 6)

9. Install the nuts and tighten all four cross member mounting bolts to 90 ft-lbs.
10. Install the three transmission mount nuts removed in step 2 and torque to 35 ft-lbs.
11. Using two 1/2” bolts and washers provided in the kit, bolt the factory gas tank skid
onto the cross member. Torque to 50 ft-lbs
12. Using a combination of factory hardware at the frame attachment points and the ½”
hardware provided for cross member attachment points, reinstall the factory
skidplates. Torque all hardware to 50 ft-lbs.
 NOTE, when installing on a 2007-2011 model with factory skids,
some minor trimming will be needed for reinstallation of the t-case
skid. See images below which show trimming.