Synergy 8022-X - Jeep JK Synergy Stage 2 Suspension System - Manual (Page 12)

Figure 11-2
• Make sure the sway bar end links are the same length by adjusting the rod ends.
• Install the sway bar link rod ends to the sway bar as shown in Figure 11-1, tighten to 60
ft-lbs.
• Install the driver side sway bar link to the sway bar relocation bracket using the stock
nut/bolt as shown in Figure 11-1. Torque the lower sway bar nut/bolts to 75 ft-lbs.
• Install the passenger side sway bar links in the side of the track bar bracket using the
stock nut/bolt. See Figure 11-3.