Synergy PPM-8055 - Manual (Page 2)

2. Remove the factory anti-sway bar links from the axle brackets, or remove completely
if using new anti-sway bar links.
3. Position the new PPM-8055 track bar bracket over the stock track bar bracket as
shown below. Secure the bracket to the axle using the supplied 9/16 x 3” bolt and
spacer, the spacer goes where the track bar was located in the stock bracket. There
are 3 cylindrical spacers included with this kit, use the shorter one for this step, the
two longer ones will be used later for the anti-sway bar relocation brackets. Use a
washer under the head of the bolt and under the toplock nut. Do not tighten this nut
at this time; wait until all the other hardware is installed.
4. Install the (2) 3/8 x 1” bolts in the track bar relocation bracket on either side of the
9/16” bolt, use a flat washer under the bolt head and under the nut, then secure with
the 3/8-24 UNF Stover nut.
5. Install the u-bolt over the axle tube and through the track bar relocation bracket, use a
flat washer and the 3/8-16 UNC nylock nut to secure the u-bolt.