Synergy 8059 - Jeep JK Front Sway Bar Links - Manual (Page 2)

2. On some models a ½” drill bit or reamer will need to be reamed through each side of the stock sway
bar to enlarge the holes for the new rod end studs.
Figure 2.1
3. Make sure the sway bar links are the same length by adjusting the rod ends.
4. Install the sway bar link rod ends to the sway bar as shown in Figure 1.1. Tighten to 60 ft-lbs.
5. If using stock mounting locations, install the sway bar link to the axle using the factory hardware and
mounting points. Torque the hardware to 75 ft-lbs.
6. If using a track bar relocation bracket, install the driver side sway bar link to the sway bar relocation
bracket using the stock nut / bolt as shown in Figure 1.1 above. Torque lower bolt and factory hardware
to 75 ft-lbs.
7. Install the passenger side sway bar link in the side of the track bar bracket using the factory hardware.
See figure 7.1 below.