Synergy 8076 - Jeep JK 2 - Manual (Page 7)

8) Torque the 3/8” U-bolts to 30 ft-lbs
9) Torque the 9/16” bolt to 150 ft-lbs.
10) Attach the track bar to the new track bar bracket with the vehicle sitting on the ground
under its own weight. It helps to have someone push the back of the vehicle from
side to side to align the track bar bushing in the new mount in the bracket. Tighten
the OEM track bar bolts to 125 ft-lbs .
11) The track bar bolt may rub the coil spring on some applications. This is often due to
the coil spring bowing because the pinion has increased. Solutions to this are as
follows:
a. Trim the end of the bolt sticking through the nut.
b. Flip the bolt around so the bolt head is adjacent to the spring.
c. Rotate the spring so the bolts are in between the coils.
d. Cut and rotate the lower spring mounts on the axle.
e. Install polyurethane lower coil wedges.
Installation is Complete