Synergy 8154 - Jeep TJ/LJ/ZJ/XJ HD Fixed Lower Control Arms - Manual

SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397
PPM-8154 TJ/LJ/ZJ/XJ FIXED LENGTH HD LCA
Version 1
GENERAL NOTES:
• These instructions are also available on our website; www.synergymfg.com.
Check the website before you begin for any updated instructions and additional
photos for your reference.
• These control arms are ¼” longer than stock to help correct caster and driveline
angles on lifted Jeep vehicles.
Installation:
1. Remove the existing lower control arms. If you are just replacing the lower control
arms, they can be replaced one at a time with the vehicle sitting on level ground,
without removing the tires & wheels or any other suspension part.
2. Reuse the factory mounting bolts. Install the arm so that the side with the offset
notch is at the axle end with the flush end of the arm positioned closest to the ground
as pictured below. This allows for greater droop travel and a smooth surface to slide
over rocks and terrain.