Synergy 8259-02 - Jeep XJ Sway Bar Link Disconnect Kit - Manual (Page 3)

Image 2.2
4) After locating the 2 holes to be used for installation, open them up slightly with a 7/16” drill bit. Be
careful not to drill into any electrical components under the hood or into the air box.
5) Once holes have been clearanced, install the bracket as shown. Use 2 of the 7/16-14 x 1” long bolts and
install with a washer under both the bolt head and nut as shown. Torque bolts to 35 ft-lbs. Installation
is complete on the driver’s side.
 Test that disconnect operates smoothly and lynch pin can easily be removed / installed.
 Note, a small amount of grease on the stud is helpful for the first few uses.