Micropump GN Series Installation, Operation and Warranty Information - Manual (Page 4)

4
DOC No: 7046 REV G
Your Micropump Product...
represents years of fluid handling experience and we feel it is the finest product
available of its type.
The product you have purchased was designed and constructed to handle compatible,
clean fluids within designated limits and conditions. Staying within performance limits
and following the guidelines given in this manual will result in excellent performance
and maximum pump life.
Should you have a question or a problem, technical assistance is available worldwide.
Micropump products are designed for easy field servicing with service kits and technical
support available for all products.
The Purpose of this Guide...
is to provide information to enable suitably qualified technicians and fitters to install,
operate and maintain Micropump pumps.
Use this Guide...
when you have purchased a pump, adaptor, or assembly including these components.
This guide contains specific information for installation, operation, and maintenance
of Micropump pumps. General information is given on installation within a system, but
reference should always be made to instructions provided with ancillary equipment
when installing the unit.
Abbreviations
The following abbreviations are used in this guide:
PEEK - Polyetheretherketone PPS - Polyphenylenesulfide
PTFE - Polytetrafluoroethylene NPSH - Net Positive Suction Head
NPT - American National Standard
Taper Pipe Thread
O/C Pump
Type Series
Modifier Design
Modifier Gear
Set . Gear
Material Seal
Material Base
Material . Drive
Mount
Base Code:
Bypass Driven
Magnet Driving
Magnet High System
Pressure Bushing
Material Shaft
Material Port
Fittings Port
Orientation Gear
Trim Other
Options Code:
Product Labeling
Micropump products are labeled with a product code. The code describes the pump
configuration and materials of construction. The first eight positions of the code
describe the base configuration. The remaining ten positions in the code describe the
optional features. Options that are not used are not shown in the code. For pumps
equipped with adapter and/or motor the product code is truncated at the design
modifier, later positions then describe the adapter and/or motor. Your Micropump
distributor can provide additional information about the product code.