Smittybilt 18604 CONTRACTORS RACK - Manual (Page 5)

For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220 / www.smittybilt.com
Installation Instructions
CONTRACTORS RACK
PART # 18604
REAR SECTION ASSEMBLY
STEP 1: Slide the rear driver side vertical upright (#5) onto the rear side rail (#2), then slide the rear cross
bar (#12) over the end of the side rail. (Fig A)
Attach using the M12x65 bolts and two quick release pins. (Fig B) Tighten snug but not completely.
Repeat same steps for rear passenger side. (Fig C)
(Fig A) (Fig B)
(Fig C) (Fig D)
NOTE: It is recommended to have an assistant while assembling and installing this product.
Rear
side rail
Driver side
rear upright Rear cross bar
M12x65
bolt sets Quick
release pins
Passenger side view
Rear drive side mounting plate