Smittybilt 56660xx G.E.A.R. Overhead Console - Manual (Page 2)

WWW.SMITTYBILT.COM
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Installation Instructions
G.E.A.R. Overhead Console
07-10 Wrangler/Unlimited
(Part # 56660xx)
Step 3: If your footman loop was bolted on, attach the front adapter bracket to the same holes using the
factory bolts you previously removed. Do not tighten completely at this time. (Fig C) Proceed
to Step 7 now.
Step 4: If your footman loop was riveted on you will need to use the windshield frame nut plate. To the
left of where the footman loop was mounted there is a slot in the windshield frame. Simply hold
the rod connected to the nut plate and slide the nut plate through the slot into the windshield
frame. (Fig D)
(Fig C) (Fig D)
Step 5: Once you have inserted the nut plate into the windshield frame slide it down until the two
threaded holes in the nut plate line up with the two holes in the windshield frame that the footman
loop was bolted too. (Fig E) It may be necessary to bend the rod on the nut plate in order to get the
correct and easiest angle to line the holes up.
Step 6: When the holes are lined up, you may now attach the front windshield adapter bracket to the
windshield frame using the included allen head machine screws as shown in Fig C.
If your footman loop was bolted on, attach the
front adapter bracket to the same holes using
the factory bolts you previously removed. Do
not tighten completely at this time.
To the left of where the footman loop was
mounted there is a slot in the windshield
frame. Simply hold the rod connected to the
nut plate and slide the nut plate through the
slot into the windshield frame.