Smittybilt 56660xx G.E.A.R. Overhead Console - Manual (Page 3)

WWW.SMITTYBILT.COM
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Installation Instructions
G.E.A.R. Overhead Console
07-10 Wrangler/Unlimited
(Part # 56660xx)
(Fig E) (Fig F)
Step 7: Install the main plate now by first setting the back portion on top of your center sport bar. (Fig F)
Then attach the front portion to the previously installed windshield adapter bracket with included
10 mm hardware. (Fig G) Do not tighten completely at this time.
(Fig G) (Fig H)
Step 8: Install the 2 sport bar clamp rings on the rear section. Do so, by sliding them around the sport bar.
(Between the sound bar and sport bar) Line them up with the notch in the plate. Do not fully tighten
at this time. (Fig H)
Once you have insert the nut plate into the windshield
frame slide it down until the two threaded holes in the
nut plate line up with the two holes in the windshield
frame that the footman loop was bolted too. It may be
necessary to bend the rod on the nut plate in order to
get the correct and easiest angle to line the holes up.
Install the main plate now by first setting the back
portion on top of your center sport bar.
Attach the front portion to the
previously installed windshield adapter
bracket with included 10 mm hardware.
Do not tighten completely at this time.
Install the 2 hose clamps on the rear section. (1 per side)
Do so, by sliding them around the sport bar (between the
sound bar and sport bar) Line them up with the notch in
the plate. Do not fully tighten at this time.