Snorkel X32-sn53100+ - Manual (Page 17)

Maintenance 504165-002
Operation Manual Page 13
M AINTENANCE
W A R N I N G ! !
Never perform service while the platform is elevated without first blocking the elevating assembly.
DO NOT stand in the elevating assembly area while deploying or storing the brace.
Figure 8: Scissor Brace
B
L O C K I N G
T
H E
E
L E V A T I N G
A S S E M B L Y
S CISSOR B RACE I NSTALLATION
1. Park the work platform on a firm, level surface.
2. Pull Chassis EMERGENCY STOP Switch to the ON position.
3. Pull Platform EMERGENCY STOP Switch to the ON posi-
tion.
4. Turn and hold the Chassis Key Switch to CHASSIS.
5. Push the Chassis Lift/Lower Switch to LIFT to elevate the
platform until the Scissor Brace can be rotated to the vertical
position.
6. X26 – From the rear of the machine, lift the Scissor Brace
from its stowed position. Rotate upward and outward, then
down until it is hanging vertically below its attachment point.
7. X32 – From the left side of the machine, pull the locking pin
securing the brace. Rotate the Scissor Brace counter clock-
wise until it is in the vertical position.
8. Lower the platform by pushing the Chassis Lift/Lower Switch
to LOWER and gradually lower the platform until the Scissor
Brace is supporting the platform.
S CISSOR B RACE S TOWAGE
1. Using the Chassis Controls, gradually elevate the platform
until the Scissor Brace is clear.
2. X26 – Rotate the Scissor Brace outward and upward over its mounting point until it rests in the stowed
position.
3. X32 – Rotate the Scissor Brace clockwise until the locking pin engages.
4. Lower the platform by pushing the Chassis Lift/Lower Switch to LOWER to completely lower the plat-
form.
Pin Rests on Brace
when in Blocking
Position
Scissor Brace in
Rest Position
Brace Rotates to
Blocking Position
Brace Rests on Pin
when in Blocking
Position