Snorkel X26N-sn51089+V-1 - Manual (Page 13)

Page 9
7 OPERATION
7 OPERATION
Before operating the work platform, ensure that the Pre-Operation Safety Inspection and System Function
Inspection have been completed and that any deficiencies have been corrected.
NOTE: Never operate a damaged or malfunctioning machine.
The operator must be thoroughly trained on this machine.
PLATFORM EXTENSION
Mount the platform and properly 1.
close and secure the entrance.
Depress the foot lever located at the
2.
rear of the platform extension. Push
the platform extension forward until
the pin engages the front stop.
To retract the platform extension,
3.
depress the foot lever and pull the
platform extension toward the rear of
the machine until the pin engages the
rear stop.
TRAVEL WITH THE
PLATFORM LOWERED
Check that the route is clear of 1.
obstacles (persons, obstructions,
holes, drop-offs, bumps, and debris),
is level, and is capable of supporting
the wheel loads.
Verify that the Chassis Key Switch
2.
is turned to ON and the Chassis
Emergency Stop Switch is ON
(pulled out).
Mount the platform and properly
3.
close the entrance.
Check clearances above, below, and
4.
to the sides of platform.
Pull the Platform Emergency Stop
5.
Switch out to the ON position.
Select DRIVE mode.
6.
NOTE: Choose between standard drive and extra torque depending on the gradient.
7. Engage the Interlock Switch and move the Control Handle to FORWARD or REVERSE to travel in the
desired direction. The speed of the machine will vary depending on how far from centre the Control
Handle is moved.
STEERING
1. Turn the Lift/Drive Switch to DRIVE.
2. While engaging the Interlock Switch, push the Steering Switch to the RIGHT or LEFT to turn the wheels
in the desired direction. Observe the tires while manoeuvring the machine to ensure proper direction.
NOTE: Steering is not self-centering. Wheels must be returned to the straight ahead position by
operating the Steering Switch.
Figure 4: Platform Extension
 3ODWIRUP([WHQVLRQ
 )RRW/HYHU GHFNORFN DVVHPEO\
1 2
1. Platform Extension
2. Foot Lever (deck lock) assembly