Snorkel SR2770 - Manual (Page 34)

Vi sually in spect the en tire length of the fuel line,
from the en gine to the fuel tank, for leaks.
■ Engine Oil
Figure 7.6 - Engine Oil Level
Keep the oil level be tween the marks on the dip -
stick  (see Fig ure 7.6).
The dis tance be tween the top and bot tom dip stick
marks cor re sponds to about 1 qt. (one li ter). Add
oil, if needed at the cap € (see Fig ure 7.6) on top of
the en gine.
See the “Specifications” chapter 3 for the
correct engine oil grade and weight.
■ Engine Coolant
Figure 7.7 - Engine Coolant Level
The Kubota engine is liquid cooled. At operating
temperatures the coolant should be at the HOT
level  (see Figure 7.7). When cold there should
be approximately 1 inch (2.5 cm) of coolant in the
bottom of the reservoir.
The coolant is half water and half ethylene glycol.
To add coolant:
Turn the engine OFF at the ground control box box
KEY SWITCH. Remove the cap € (see Figure 7.7)
from the coolant reservoir. Add coolant and replace
cap.
■ Radiator Cap
Figure 7.8 - Radiator Cap
Vi sually check to see that the cap is in place and
tight.
■ Swinging Gate
Figure 7.9 - Swinging Gate
In spect the gate to see that it swings freely, latches
se curely, and is not de formed in any way.
■ Wiring Harnesses and Connectors
Inspect all the wiring harnesses, on the machine,
for loose connections, broken wires, and frayed
insulation.
SR2770 – 11669A page 7 - 3
7. Daily Inspection and Maintenance