Snorkel SR3370 - Manual (Page 30)

n Circuit Breakers
q Main breaker
Figure 5.4 - Main Circuit Breaker
There is only one cir cuit breaker, on a stan dard SR,
that is ac ces si ble to the op er a tor. Its pur pose is to
pro tect the elec tri cal cir cuits from elec tri cal over -
loads. When the cir cuit breaker trips (pops out)
push it back in then at tempt to use the SR.
If the cir cuit breaker trips a sec ond time, take the
SR out of ser vice and re fer the prob lem to a qual i -
fied trained ser vice tech ni cian for repair.
q RCD / ELCB outlet (option)
Figure 5.5 - RCD/ELCB Outlet
The RCD (Re sid ual Cur rent De vice) is lo cated at
the ground and will pro tect against short cir cuits to
earth. When there is a short cir cuit the RCD will
shut down the 230v AC power to the plat form out -
let.
To re set the out let dis con nect the power tool lead
from the plat form box and re set the RCD at the
ground.
If the prob lem per sists call a trained ser vice tech ni -
cian.
page 5 - 2 Rev B SR3370 & SR2770 – 12696A
5. Automatic Shut-offs and Circuit Breakers