Operating the stabilisers manually 8-8, To set the stabilisers 8-8, To raise the stabilisers: 8-8 – Snorkel SR3370 User Manual
Page 54: Manual operation, 8-8, Operating the stabilisers manually -8, Operation
n Operating The Stabilisers Manually
q
To set the stabilisers
1. The engine must be running and the SR set
for platform control box operation.
Figure 8.20
2. Pull and hold the Stabiliser switches • (see
Figure 8.20)backward, one at a time, until all
four stabiliser pads
€ (see Figure 8.21)
contact the ground.
Figure 8.21
Figure 8.22
3. Visually check the bubble level • to
determine which stabilisers must be further
extended to level the platform (see Figure
8.22).
NOTE
When the bubble
‚ in the bubble level is in the
center of the ring
ƒ, the platform is level.
4. Lower the appropriate stabilisers just enough
to center the bubble
‚ (see Figure 8.22).
When the Lift Indicator Light
„ (see Figure
8.23) comes on, the platform can be safely
raised.
Figure 8.23
q
To raise the stabilisers:
1. Completely lower the platform.
Figure 8.24
2. Push and hold the Stabiliser switches …
forward until all the stabilisers are completely
up (see Figure 8.24).
page 8 - 8
Rev B
SR3370 & SR2770 – 12696A
8. Operation