Snorkel TB50(mfg before 2/1/01) - Manual (Page 8)

1. SAFETY
1 - 2 P/N 0074333
Y Y
Electrocution
The TB 42/420/50 is an all-metal boom, NON-
INSULATED, aerial work-platform. Do not
operate it near ELECTRICAL conductors.
Regard all conductors as being energized.
Do not operate outside during a thunderstorm.
Y Y
Tipover & Falling Hazards
Do not operate a TB 42/420/50 from a position
on trucks, trailers, railway cars, floating vessels,
scaffolds, or similar equipment unless the
application is approved in writing by Snorkel.
If the platform or elevating assembly becomes
caught, snagged, or otherwise prevented from
normal motion by an adjacent structure or other
obstacles such that control reversal does not free
the platform, remove all personnel from the
platform before attempts are made to free the
platform using ground controls.
It is best not to transfer from the platform to
another structure or from the structure to the
platform, unless that is the safest way to do the
job. Judge each situation separately taking the
work environment into account. If it is necessary
to transfer from the platform to another structure
the following guidelines apply:
•
Where possible, place the platform over a roof
or walking structure to do the transfer.
•
Transfer your anchorage from one structure to
the other before stepping across.
•
Remember that you might be transferring to a
structure where personal fall arrest is
required.
•
Use the platform entrance, do not climb over
the guardrails.
All platform occupants MUST wear a fall restraint
device connected to a lanyard anchor point.
Do not exceed the unrestricted platform capacity
as indicated on the capacity placards at the
platform and ground-control panel.
Do not raise the boom if the TB 42/420/50 is on
soft ground. Operate the boom only on a firm
surface capable of withstanding all load forces
imposed by the aerial platform in all operating
conditions.
Do not carry loads from any point outside of the
platform.
Care shall be taken to prevent rope, electric
cords, and hoses, etc., from becoming entangled
in the aerial platform,
Raise the platform only when the TB 42/420/50 is
on level ground.
Maintain a firm footing on the platform floor.
Climbing on the guardrails is prohibited.
Do not use ladders, planks, or other devices to
extend or increase your work position from the
platform.
Do not jerk the controls. Move the controls slowly
and deliberately to avoid jerky and erratic
operation. Always stop the controls in the neutral,
off, position before going in the opposite
direction.
Do not use the boom for any purpose other than
to position personnel, their tools, and materials.
Do not use the TB 42/420/50 as a crane, hoist,
or jack.
Do not operate the TB 42/420/50 in winds, or
wind gusts, of 28 mph (45 km/hr) or more.
Do not add anything to the TB 42/420/50 that will
increase the wind loading (billboards, banners,
flags, etc).
Y Y
Crushing
Always look in the direction of travel. Avoid
overhead obstructions.
Never cover the floor grating or otherwise
obstruct your view below.
Make sure the area below the platform is free of
personnel before lowering.
„
GENERAL SAFETY PRECAUTIONS
Y Y
Personnel Precautions
If you encounter any suspected malfunction of
the aerial platform, or any hazard or potentially
unsafe condition relating to capacity, intended
use, or safe operation, cease operation and seek
assistance from management.
Y Y Operator General Precautions
Make sure that all protective guards, cowlings,
and doors are in place and secure.
Be sure the guardrail system, including the gate,
is in place and secure.