Safety instructions contents proper use – IKA MTS 2/4 digital User Manual
Page 8
Page
Warranty
2
Safety instructions
8
Proper use
8
Unpacking
9
General information
9
Commissioning
10
Motor protection
11
Error codes
11
Maintenance and Cleaning
12
Technical data
12
List of spare parts MTS 2/4 digital
18
Spare parts diagram MTS 2/4 digital
19
When adjusting the speed, pay careful attention to the containers
fastened onto the agitation table to prevent the medium to be sha-
ken from possibly splashing out. Select the speed based on how
full the container will be so as to prevent the medium from splas-
hing out. Observe applicable safety instructions and guidelines as
well as work protection and accident prevention requirements for
use in the laboratory. Avoid bumping and striking the agitation
table. Even minor damage that cannot be detected may result in
damage to the motor bearing. Careful handling will ensure safe
working and a long service life for the device.
If you notice that the device is not running smoothly, the speed
must always be reduced until no more unevenness occurs in the
operation.
Make certain that the
device is equipped with
at least two diagonally
offset or four micro-titer
plates, whether or not
these are completely fil-
led. Never operate the
device without micro-
titer plates. Otherwise,
resonance may arise
when it runs at high speeds.
The micro-titer plates used for the agitation process must be secu-
rely fastened on the agitation table. Make certain in this regard to
lock the round band for clamping the micro-titer plates. It must be
replaced when necessary before it is too worn.
Only a specialist may open the device.
ATTENTION! Covers or parts that can be removed
from the device must be put in place on the device in
order tro ensure safe operation.
The IKA MTS 2/4 digital was not constructed for operation in dan-
gerous atmospheres, for mixing dangerous substances or for ope-
ration under water.
The instrument may not be operated in rooms with explosion
hazards. The device must be places on a level and skid-free hol-
ding surface.
Use only original IKA accessories.
The IKA MTS 2/4 digital is designed for agitating from two to four
micro-titer plates.
8
012002
Safety instructions
Contents
Proper use