Eppendorf Temperature Verification System - Manual (Page 7)

Temperature Verification System USB – Single-channel — Operating manual
7
2 Product description
2 Product description
2.1 Delivery package
2.1.1 Temperature Verification System USB – Single-channel
For Mastercycler nexus, Mastercycler pro, Mastercycler ep, Thermomixer and ThermoStat
1× measuring device
1× plug head line (connecting cable between measuring device and temperature sensor)
1× mains/power supply device
4× international plug adapter
1× operating manual
1× device case
2.1.2 Temperature sensor 96 Well
1× Temperature sensor 96 Well
1× certificate
2.1.3 Temperature sensor 384 Well
1× Temperature sensor 384 Well
1× silicone mat for the Temperature sensor 384 Well
4× spacers
1× bottle with parrafin oil (25 mL)
1× certificate
2.1.4 Temperature sensor 1,5 mL
1× Temperature sensor 1,5 mL
1× certificate
2.2 Features
2.2.1 Temperature Verification System USB – Single-channel
The Temperature Verification System USB – Single-channel enables simple and fast inspection
of the block temperature of the following Mastercycler products:
•
Mastercycler nexus
•
Mastercycler pro
•
Mastercycler ep
The Temperature Verification System USB – Single-channel requires a minimum software
version in the control panel of the thermal cycler.
This table contains the minimum software versions required to use the Temperature Verification
System USB – Single-channel. If the device or CycleManager pro software has an older version,
install the software version listed below.
Hint!
•
The term "validation" has been replaced by "verification" in these
instructions. The term "validation" is still used in older software versions.
•
The term "calibration" has been replaced by "adjustment" in these
instructions. The term "calibration" is still used in older software versions.