Eppendorf ThermoMixer FP - Manual (Page 22)

Eppendorf ThermoMixer F1.5/FP — Operating manual
22
6 Troubleshooting
6 Troubleshooting
If you cannot remedy an error with the recommended measures, please contact your local
Eppendorf partner. The contact address can be found online at: www.eppendorf.com/worldwide.
6.1 General errors
6.2 Error messages
Symptom/
message
Cause Remedy
Display remains
dark.
•
No mains connection.  Check the mains connection
and the power supply.
 Switch on device.
Set temperature is
not reached.
Set temperature is less than 4 °C
above ambient temperature.
 Set up the device in a cooler
environment.
ThermoTop LED
does not light.
•
The interface between the
device and the ThermoTop is
dirty.
 Remove any dirt from the front
of the ThermoTop.
 Remove any dirt from the top of
the device, especially from the
viewing window beside the
heating/cooling plate.
ThermoTop does
not fit on the device.
The lid is attached to the
thermoblock.
 If using the ThermoTop, do not
use the lid.
The device does
not mix or control
the temperature.
Various causes are possible.  Contact your local Eppendorf
partner.
Symptom/
message
Cause Remedy
Error message
preceded by a
number code.
•
Various causes are possible. 1. Switch off device and wait
10 seconds.
2. Switch on device.
If the error message appears again,
contact your local Eppendorf
partner.
EN
Operating manual