4 electrical connections, 5 install the platform, Electrical connections – Eppendorf 2350 Biological Shakers Innova User Manual

Page 18: Install the platform

Advertising
background image

Installation
New Brunswick

Innova

®

2300/2350 Shakers

English (EN)

18

4.4

Electrical connections

Before making electrical connections, be sure to follow these instructions:

1. Check that the power module at the rear of the unit is set to the correct voltage, corresponding to your

power source.

2. Remove the caution label from the universal power module.

3. Make sure the plastic straps have been removed from the upper bearing housing.

4. Make sure the power switch on the back of the unit is set in the OFF position.

ONLY THEN:

5. Connect the line cord to the power module and to a grounded electrical outlet.

4.5

Install the platform

The Innova 2300/2350 can be used with a variety of Eppendorf platforms that will accept a wide range of
clamps for flasks, test tubes, etc. A platform, which is required for operation, is a separate item not included
with the shaker assembly (see

Platform capacity on p. 29).

WARNING!

Do not position the equipment so that it is difficult to operate the disconnecting device
(main plug).

For service reasons and for cases of emergencies, sufficient space must be provided for
easy access to the main power cord/power switch (located at the back of the unit).

WARNING! Risk of electric shock and/or damage to device!

Use a grounded power supply.

CAUTION!

A detachable main power cord has been provided with your unit.

Only use the cord provided with the unit.

CAUTION! Risk of damage to the device!

Never run the shaker without a properly installed platform.

Advertising
This manual is related to the following products: