Eppendorf 2350 Biological Shakers Innova - Manual (Page 19)

Installation
New Brunswick ™ Innova ® 2300/2350 Shakers
English (EN)
19
A platform must be installed on the device prior to use. To install a platform:
1. Set the power switch in the Off position.
2. Using the 7/32 in hex key provided, remove the 4 Allen head platform screws installed in the
subplatform of the bearing housing (under the shaker).
One of the 4 screws has a tag so you can identify the platform screws. Set them aside for reuse.
3. Place the platform on top of the shaker’s subplatform.
Be sure to use the proper size platform for your particular model shaker
4. Reinstall and tighten the 4 platform screws (previously set aside) with the hex key to secure the
platform.
4.6 Quick change platform option
If the quick change platform option is installed:
1. Slip the appropriately sized platform between the side guides and push the platform to the rear retainer.
2. Press down on the front edge of the platform.
The platform should snap down into place and be retained by the springs.
3. Check that the rear edge of the platform is engaged under the bend of the rear clip.