Eppendorf FA-45-6-30 - Manual (Page 3)

3
Instructions for use
Rotor FA-45-48-11, FA-45-20-17, FA-45-6-30
English (EN)
4 Replacing the rotor lid seal
4.1 Removing the seal

Lift the rubber seal from the groove. If necessary, use a blunt lever, for instance the rounded
side of a paper clip.
Please take care not to damage the seal.
4.2 Inserting the seal
1. Check the integrity of the seal.
Do not use any damaged, discolored or dirty seals.
2. Insert the seal in one location along the groove and spread with the fingers along the outer
edge of the lid until the seal is fully seated in the groove.
3. Place the lid on the rotor and close the lid.
4. Remove the lid and check that the seal is seated correctly
NOTICE! Faulty sealing when the seal is handled incorrectly.

Uniformly insert the seal.

Do not pull the seal lengthwise.
If the seal is too long or too short remove it from the groove and repeat the inserting
process.