JLG M4069 Operator Manual - Manual (Page 31)

SECTION 2 - USER RESPONSIBILITIES, MACHINE PREPARATION AND INSPECTION
3121638 – JLG Lift – 2-9
GENERAL
Begin the “Walk-Around Inspection” at Item 1, as noted on the
diagram. Continue Left (counterclockwise viewed from top)
checking each item in sequence for the conditions listed in
the following checklist.
TO AVOID POSSIBLE INJURY, BE SURE MACHINE POWER IS “OFF” DURING
“WALK-AROUND INSPECTION”.
NOTICE
DO NOT OVERLOOK VISUAL INSPECTION OF CHASSIS UNDERSIDE. CHECK-
ING THIS AREA OFTEN RESULTS IN DISCOVERY OF CONDITIONS WHICH
COULD CAUSE EXTENSIVE MACHINE DAMAGE.
NOTE: On each item, make sure there are no loose or missing
parts, that they are securely fastened, and that no visi-
ble damage exists in addition to any other criteria men-
tioned.
1. Platform Control Console - Placard secure and legi-
ble, control lever and switches return to neutral,
control lever lock and emergency stop switch func-
tion properly, manual in storage box.
2. Leveling Jacks - See Note
3. Spindle, Tie Rod and Steer Linkage (left front) - See
Note
4. Wheels and Tires -Properly secured, no missing lug
nuts. Refer to section 6, Tires and Wheels. Inspect
wheels for damage and corrosion
5. Steer Cylinder - See Note
6. Hydraulic Reservoir - Recommended hydraulic fluid
level on level indicator on tank. Breather cap secure
and working.
7. Hydraulic Pump - See Note
8. Hydraulic Motor - See Note
9. Battery Compartment - Proper electrolyte level.
10. Battery Disconnect - See Note
11. Oscillating Axle, Oscillation Cylinder - See Note
12. Drive Hubs - See Note
13. Brake, Left Rear - See Note
Figure 2-2. Walk-Around Inspection (Sheet 2 of 3)