JLG 120-SXJ ANSI Operator Manual - Manual (Page 60)

SECTION 4 - MACHINE OPERATION
4-10 – JLG Lift – 3121104
6. Push and hold the Jack/Steer/Axle Select switch in
the Axle position.
7. Position Drive/Steer/Jacks/Axle controller located on
platform control console to Extend Axles until axles
are fully extended and the Axles Set light is on.
8. If the light does not illuminate when the axles are
fully extended, contact a qualified service technician
before continuing operation.
NOTE: If no function is selected and the power is still on, the
jack will automatically retract after a period of 7 sec-
onds.
9. Push and hold the Jack/Steer/Axle Select switch in
the Jack position.
10. Position Drive/Steer/Jacks/Axle controller located on
platform control console to Retract Jack position
until the jack is fully retracted.
11. Repeat steps 1 thru 10 for the opposite axle.
4.10 AXLES, EXTENDING AND RETRACTING
W/REMOTE CONTROL BOX
MAKE SURE THAT PERSONNEL ARE CLEAR OF CHASSIS AT
ALL TIMES WHEN JACKS ARE EXTENDED.
JACKS RETRACT AUTOMATICALLY, LOWERING THE CHASSIS.
THE JACKS ARE TO BE USED FOR EXTENDING AND RETRACT-
ING THE AXLES. THEY ARE NOT TO BE USED AS A MAINTE-
NANCE TOOL.
1. Activate the machine hydraulic system and position
the boom over the drive wheel end of the machine.
2. Position the Steer Select switch to the Front Steer
position. The boom must be retracted within the lim-
its of the 10 foot cutout switch and below horizontal.
3. Position the Front/Rear Jack switch to the desired
jack.