JLG 120-SXJ ANSI Operator Manual - Manual (Page 61)

SECTION 4 - MACHINE OPERATION
3121104 – JLG Lift – 4-11
4. Push and hold the Jack/Steer/Axle Select switch in
the Jack position.
5. Position the Front Steer/Jacks/Axle switch to the
Extend Jack position until the jack is fully extended.
.
6. Push and hold the Jack/Steer/Axle Select switch in
the Axle position.
7. Position Front Steer/Jacks/Axle switch to the Extend
Axle position until axles are fully extended and the
Axles Set light is on.
8. If the light does not illuminate when the axles are
fully extended, contact a qualified service technician
before continuing operation.