JLG 600A_AJ Parts Manual - Manual (Page 125)

3121617 600A 600AJ 2-85
SECTION 2 TURNTABLE
19E cont’d 70001974 1 Decal - Terminal Connections
19F 70001973 1 Decal - Warning Moving Parts
20 0641808 2 Bolt 1/2in-13NC x 1in
21 Not Used
22 0902888 1 Bracket, Box Mounting
23 A/R Flatwasher 1/2in Options:
4711800 Flatwasher 1/2in Thin
4891800 Flatwasher 1/2in Hardened
24 4711400 A/R Flatwasher 1/4in Thin
25 to 27 Not Used
28 4240018 A/R Tie-strap (Not Shown)
29 4791400 2 Starwasher 1/4in
30 1 Bolt 1/4in-20NC Options:
0641403 Bolt 1/4in-20NC x 3/8in
0641404 Bolt 1/4in-20NC x 1/2in
31 3740080 2 Relay (Deutz D2011 Engines Only
32 0100019 A/R Compound, Locking
33 1 Connector, Strain Relief Options (Deutz D2011 Engines
Only):
4460051 60Hz (ANSI & ANSI Export Specs)
See Note 50Hz (ANSI Export, Australian & CE Specs) (Note: Not
Available - Purchase Locally)
34 1 Connector, Strain Relief Options:
4460071 60Hz (ANSI & ANSI Export Specs)
See Note 50Hz (ANSI Export, Australian & CE Specs) (Note: Not
Available - Purchase Locally)
35 3311405 A/R Locknut 1/4in-20NC
36 A/R Bolt 1/4in-20NC Options:
0641406 Bolt 1/4in-20NC x 3/4in
0641405 Bolt 1/4in-20NC x 5/8in
37 1 Belt, Drive Options:
0480129 60Hz & Deutz D2011 Engine (ANSI & ANSI Export Spec)
1001142646 60Hz & Deutz DT2.9L4 Engine (ANSI & ANSI Export Spec)
0480126 50Hz (ANSI Export, Australian & CE Specs)
38 4032015 4 Capscrew M10 x 55mm
39 4300157 1 Stud
40 3311801 1 Nut 1/2in-13NC
41 0100062 1 Loctite, #RC680
42 2820031 1 Insulator
43 1 Control Box Assembly Options:
0861538 1 60Hz Control Box Assembly (ANSI & ANSI Export Specs)
0861572 1 50Hz Control Box Assembly (ANSI Export, Australian & CE
Specs)
7024488 1 Card, Circuit - Generator Power
See Note 1 Fuse (Note: Not Available - Purchase Locally)
7024489 1 Card, Circuit - Control
Ref. Note: Same Circuit Card (P/N 7024489) is used for
both 60Hz & 50Hz. When replacing card, rocker
switch on card must be set for required application.
70000619 1 Harness, Circuit Card
FIGURE 2-19. 7500W SKYPOWER GENERATOR INSTALLATION - DEUTZ ENGINES
ITEM # PART NUMBER QTY. DESCRIPTION REV.