JLG 600A_AJ Parts Manual - Manual (Page 64)

2-24 600A 600AJ 3121617
SECTION 2 TURNTABLE
405 4 Injector, Fuel
4 Pump, Injector Options:
Series A Injector
Series B Injector
Series C Injector
Series D Injector
4 Gasket Options (1 per Injector)
406 1 Filter, Fuel
407 1 Pump Fuel Supply
Repair Kit for Pump
Hand Pump
Seal, Hand Pump
1 O-Seal Between Fuel Pump & Engine Block (Not Shown)
408 4 Gasket, Intake Manifold (Not Shown)
409 1 V-Belt
410 4 Gasket, Exhaust Manifold to Engine Block (Not Shown)
1 Gasket, Exhaust Manifold to Exhaust Pipe (Not Shown)
411 1 Alternator
1 Regulator, Voltage Options (Not Shown)
1 Seal, Gasket for Voltage Regulator (Not Shown)
1 Bracket, Adjusting (Not Shown)
412 1 Starter
1 Relay
1 Shield, Starter Heat
413 2 Plug- In Connector (Not Shown)
414 1 Transmitter, Temperature
1 Ring, Sealing (Note: Not Available for Purchase.)
415 1 Sensor, Oil Pressure
416 1 Sensor, Speed
417 1 Actuator, Throttle
2 Spring, Actuator
418 1 Thermostat (Located at rear of engine block - Not Shown)
1 Spring, Compression
419 1 Flywheel (Not Shown)
1 Ring Gear (Located on Flywheel - Not Shown)
420 1 Sender, Temperature
421 1 Module, Control
1 Harness. EMR2 Module
422 4 Plug, Glow (Not Shown)
423 1 Solenoid, Start
424 1 Breather Valve (Not Shown - Located On Front Cover)
1 Seal, Breather Valve
425 1 Harness. Engine (Not Shown)
1 Plug, Connector
426 1 Gasket, Head (Not Shown)
427 1 Kit, Timing Belt/Idler (Not Shown)
FIGURE 2-6. DEUTZ D2011ENGINE INSTALLATION (CONTINUED)
ITEM # PART NUMBER QTY. DESCRIPTION REV.