JLG E45A_AJ Operator Manual User Manual

Page 24

Advertising
background image

SECTION 2 - PREPARATION AND INSPECTION

2-8

– JLG Lift –

3120883

2.7

BATTERY MAINTENANCE AND
CHARGING

Battery Maintenance, Quarterly

1.

Open battery compartment cover to allow access to
battery terminals and vent caps.

WHEN ADDING WATER TO BATTERIES, ADD WATER UNTIL ELEC-
TROLYTE COVERS PLATES. DO NOT CHARGE BATTERIES
UNLESS ELECTROLYTE COVERS THE PLATES.

NOTE: When adding distilled water to batteries, non-metallic

containers and/or funnels must be used.

To avoid electrolyte overflow, add distilled water to
batteries after charging.

When adding water to the battery, fill only to level
indicated or 3/8" above separators.

2.

Remove all vent caps and inspect electrolyte level of
each cell. Electrolyte level should be to the ring
approximately one inch from top of battery. Fill bat-

teries with distilled water only. Replace and secure
all vent caps.

3.

Remove battery cables from each battery post one
at a time, negative first. Clean cables with acid neu-
tralizing solution (e.g. baking soda and water or
ammonia) and wire brush. Replace cables and/or
cable clamp bolts as required.

4.

Clean battery post with wire brush then re-connect
cable to post. Coat non-contact surfaces with min-
eral grease or petroleum jelly.

5.

When all cables and terminal posts have been
cleaned, ensure all cables are properly positioned
and do not get pinched. Close battery compartment
cover.

6.

Start hydraulic system and ensure that it functions
properly.

24.

Tie Rod Ends and Steering Spindles - No loose or
missing parts; no visible damage. Tie rod end stubs
locked.

25.

Drive Wheel/Tire Assembly, Left Rear - Properly
secured; no loose or missing wheel bolts; no visible
damage.

26.

Ground Controls - Switches operable; no visible
damage; emergency stop switch functions prop-
erly; placards secure and legible.

27.

Manual Descent Valve - No visible damage; no evi-
dence of leakage.

28.

Cowling and Latches - All cowling, doors and
latches in working condition; properly secured; no
loose or missing parts.

29.

Battery Compartment - Batteries have proper elec-
trolyte level; cables tight; no visible damage or cor-
rosion.

30.

Control Valve - No loose or missing parts; evidence
of leakage; unsupported wires or hoses; damaged
or broken wires.

31.

Swing Motor and Worm Gear - No loose or missing
hardware; no visible damage; evidence of proper
lubrication.

32.

Drive Wheel/Tire Assembly, Left Rear - Properly
secured; no loose or missing wheel bolts; no visible
damage.

33.

Frame - No visible damage; no loose or missing
hardware (top and underside).

34.

Cowling and Latches - All cowling, doors and
latches in working condition; properly secured; no
loose or missing parts.

35.

Platform Pivot Pins - Properly secured.

36.

Platform Gate - Latch and Hinges in working condi-
tion; properly secured; no loose or missing parts.

Figure 2-2., Daily Walk-Around Inspection

(Sheet 3 of 3)

Advertising
This manual is related to the following products: