JLG 40RTS ANSI Operator Manual - Manual (Page 30)

SECTION 3 - USER RESPONSIBILITIES AND MACHINE CONTROL
3-4 – JLG Sizzor – 3120690
Platform Control Station
1. Enable Switch -These machines are equipped with
an enable switch on the side of the platform control
console. On machines built with a serial number
before 0200058922, the enable switch must be
pressed before activating the drive, lift or steer func-
tions. A built-in timer shuts off power to these func-
tions if they are not activated within 3 seconds after
the enable switch is depressed. In addition, this
timer will shut off power to the drive and lift functions
3 seconds after they are deactivated, making if nec-
essary to depress the enable switch before activat-
ing drive and lift again. The steer function, unless
activated in conjunction with the drive or lift func-
tions, will automatically cut off after 3 seconds of
operation. On machines built from, and including,
serial number 0200058922, the enable switch must
be depressed and held for the duration of lift. The
enable switch works in conjunction with the lift
switch only.
2. Ignition/Emergency Stop Switch - A red ignition/
emergency stop mushroom-type switch is provided
in order to turn on machine power in the platform
and also to turn off machine power in the event of an
emergency. Power is turned on by positioning the
switch to the up (on) position, and is turned off by
positioning the switch to the down (off) position.
3. Start Button - A momentary contact, push-button-
type switch that supplies electrical power to the
starter solenoid when the ignition/emergency stop
switch is in the on position and the start button is
depressed.
Figure 3-2. Platform Control Station